1. Fusing Lamp [A] ( x 2)
• The colored cable must be at the hot roller gear side.
2. Guide plate [B] (3 hooks)
3. Hot roller strippers [C] (1 spring x each)
4. Hot roller [D] (2 x C-rings, 1 x gear, 2 x bushings)
• Before removing the hot roller from the unit, remove the gear and the pin first,
• Use a small screwdriver to separate the guide plate from the unit.
• Before installing the new hot roller, peel off 3 cm (1 inch) from both ends of the protective sheet
on the new hot roller. Be sure to remove the remaining paper before starting the machine.
Fusing
39
To Next Page
