1st/2nd Message Problem/Solution
Remove Misfeed Paper Tray/ Pull out
Tray
Paper is jammed in the specified input paper tray.
• Remove paper from the input paper tray.
• Reload paper.
• Open and close front cover to extinguish message.
Remove Paper Standard Tray
The standard output tray is full.
• Remove paper from output tray.
Replace Maintenance Kit
It is time to replace: feed roller, transfer unit, fusing unit,
development unit.
Replace Print Cartridge Print cartridge requires replacement.
Replace Print Cartridge Print cartridge requires replacement (out of toner).
Replace Print Cartridge Print cartridge requires replacement (used toner tank full).
Replace Print Cartridge soon
The print cartridge is out of toner or has reached the end of its
service life. Print cartridge requires replacement.
Reset Fusing Unit correctly
Fusing unit not set correctly, or incorrect type installed.
• Check the type of fusing unit installed.
• Confirm that unit is installed correctly.
Reset Print Cartridge
AIO unit not installed or is not installed correctly.
• Insert AIO.
• Check that it is inserted properly.
Reset Tray # or Form Feed
Specified paper input tray is not set correctly. (Current resident
printer languages only).
• Set input tray correctly.
Reset the Job or Form Feed/ Paper
Size:, Paper Type:
Actual paper type and size do not match the paper tray size
and type setting.
• Load the indicated tray with the correct paper.
• Or, change the paper size using tray dial or operation
panel.
• Or, push [Form Feed] to print on current paper.
• Or, cancel job.
Error Messages
73
To Next Page
Loading...
