32DF9T02.B
3 - 4
B. MAINTENANCE MECHANIC CHECKLIST
MAINTENANCE MECHANIC CHECKLIST
F9T MIRAGE
Date: Vehicle #: Lift serial #:
Checked safety issues require repairing before vehicle is returned to service.
Zep Formula 50 R.T.U, part #599A or equivalent;
(use to clean decals and platform)
Zep I.D. Red, part #399C or equivalent;
(use to clean carriage assembly)
Suggested solvents, cleaners, and lubricants:
Zep PLS, part #497C or equivalent;
(use to lubricate carriage assembly)
Initial boxes as appropriate OK Requires
repair
Repair at next
service
Repair before re-
turning to service
Platform is clean. Non-skid strips are
attached and in good condition.
Platform deploys and lowers to ground.
Check manual pump operation and hy-
draulic fluid level. Use Texaco No.1554
aircraft hydraulic fluid (or equivalent
U.S. mil spec H5606G oil).
Front roll stop opens.
Safety
issue
Raise platform; verify that outboard roll
stop is closed and locked by pushing
against roll stop.
Check all decals. Decals should be
readable and attached securely.
Safety
issue
Bridgeplate (rear barrier) is up (at 90
degrees to platform).
Safety
issue
Raise platform to floor level; bridgeplate
must overlap floor 1”– 2".
Stow platform from floor level. Platform
must stow completely, without binding.
Check cylinder, hydraulic lines, and
connections for leaks.
Clean carriage assembly with Zep I.D.
Red degreaser.
Inspect and lube four carriage rollers
and torque limiting clutch assembly.
Remove excess grease.
To Next Page
Loading...
Need help?
General
