17
ASSEMBLY
TO OPEN THE LEG STAND
See Figures 9 - 11
Grasp the grips on the saw table and stand it upright as
shown below.
Step on the release lever and pull the grips toward you
at the same time.
Once the leg stand is released from the release lever,
ease the leg stand toward the floor by pushing the grips
toward the floor.
With your hands on the grips, push the leg stand towards
the ground until the table saw is in an open position.
NOTE: The release lever will close over the center brace
locking the leg stand in an open position.
GRIPS
LEG
STAND
CENTER
BRACE
RELEASE
LEVER
RELEASE
LEVER
Fig. 9
Fig. 10
Fig. 11
To Next Page
Loading...
