What does code S07 mean on my Riello MULTI SENTRY MST 80?
If your Riello UPS displays code S07, it indicates that the batteries are flat and the UPS is waiting for the battery voltage to exceed the set threshold. You can either wait for the batteries to recharge or manually force power-on via the “ON” menu.
What does it mean when my Riello UPS shows codes A39, A40 and the replace batteries LED is on?
If your Riello UPS displays codes A39 or A40 and the red "Replace Batteries" LED is on, it means the batteries haven't passed their periodic efficiency test. It's recommended to replace the batteries, as they may no longer provide sufficient autonomy. Battery replacement must be performed by qualified personnel.
What to do if there is no load voltage arriving from my Riello UPS?
If there is no load voltage from your Riello UPS, consider these possibilities: 1. Check that the load is properly connected to the output terminals. 2. Ensure that the switch behind the door (SWOUT) is closed. 3. Verify that the UPS is not in standby mode. If it is, perform the startup sequence. 4. Confirm that the Stand-by OFF mode is not selected, as this mode only powers loads during blackouts. 5. If the UPS has malfunctioned and the automatic bypass isn't working, insert the manual bypass (SWMB) and contact the nearest service center.
What to do if Riello UPS does not go into standby mode with mains power?
If your Riello UPS doesn't enter standby mode despite mains power, check the following: * Ensure the mains are correctly connected to the input terminals as per the installation instructions. * Verify the neutral connection is present, as the UPS requires it to operate. Failure to connect the neutral can damage the UPS or the load. * Confirm the switch behind the door (SWIN) is closed. * Check for a blackout; verify the presence of mains voltage. If there is no mains voltage, switch on via batteries to power the load. * Check for upstream protection intervention and reset the protection, ensuring there is no output overload or short to the UPS.
Terminal board layout and connection points for MST 60-80-100 models.
Initial steps and requirements for setting up the UPS installation.
Table specifying cable sizes for input, output, and battery connections.
How the UPS protects against short-circuit conditions.
Recommendations for external AC protection devices for the input line.
Requirements for surge protectors and fuses for the external battery line.
Introduction to the PowerShield³ software for UPS management.
To Next Page
General