21
• To adjust the seat height, you must loosen
the clamping screw for the seat post.
• Now you can adjust the seat post height.
Make sure that the seat post is greased.
If the seat post feels tight, clean and re
-
grease both surfaces. Never force the seat
post and if you have further issues, please
contact your local dealer for further advice.
• Align the saddle in the direction of
travel and tighten the clamping
screw to a torque of 9–12 Nm.
• Check the tightness of the seat post. Try to
twist the saddle. If it doesn’t twist, the seat
post is tight.
• Double check to make sure the leg exten
-
sion is correct. Verify that you can easily
and safely reach the ground. If this is not
the case, position the saddle lower.
Never ride when the minimum
insertion mark on the seat post
is visible. This indicates that
the seat post is not inserted far
enough into the frame. It could
break or damage the frame. If
the seat post is ever shortened, a
minimum of 80 mm must remain
in the seat tube!
DANGER!
To Next Page
Loading...
