64
KICKSTANDS
MOUNTING KICKSTAND
Almost all Riese & Müller E-bikes are fitted
with a rear kickstand which is attached di
-
rectly to the left dropout. Regularly check to
see if these screws are tight.
KICKSTANDS AT HS MODELS
According to StVZO the Riese & Müller and
blueLABEL HS models are fitted with an
automatic folding kickstand. Please notice
that a HS model can fall over and may get
damaged or damage other vehicles.
ATTENTION!
A loose screw may result in damage
to the kickstand mount!
PEDALS
INSTALLATION OF PEDALS
Grease the pedal threads before installa
-
tion and screw in the right pedal by hand
CLOCKWISE 2 – 3 rotations. The right pedal
is stamped “R”. Screw in the left pedal in by
hand COUNTERCLOCKWISE 2 – 3 rotations.
The left pedal is stamped “L”.
Tighten the pedals to a torque of 35 Nm
using a torque wrench.
The stamp is located either directly
adjacent to the threads or on the
top side of the pedal body.
ATTENTION!
To Next Page
Loading...
