Chapter 7 Burst
DG4000 can output waveform with specified number of cycles (called Burst) from
a single channel or from dual channels at the same time. DG4000 supports control
of burst output by internal, manual or external trigger source; supports three kinds
of burst types including N cycle, infinite and gated. The generator can use Sine,
Square, Ramp, Pulse, Noise (only for gated burst) or arbitrary waveform (except
DC) to generate burst.
Subjects in this chapter:
To Enable Burst Mode
Burst Type
Burst Phase
Burst Period
Gated Polarity
Burst Delay
Burst Trigger Source
Trigger Output Edge
To Next Page
Loading...
