Step-By-Step Output Mode
DG4000 supports step-by-step output of arbitrary waveform. Press Arb to open
the arbitrary waveform setting menu and press Step-By-Step to enable the
step-by-step output mode of arbitrary waveform.
In step-by-step output mode, the generator calculates the frequency
(30.517578125kHz) of the output signal automatically according to the wave table
length (16,384) and sample rate. The generator outputs waveform points one by
one at this fixed frequency. Step-by-step output mode can prevent the loss of
important waveform points.
To Next Page
Loading...
