Restore Default
Restore the generator to its default state or user-preset states.
Default State: the parameter values are as shown in the table below. Note
that items marked with “*” will not be affected by the preset operation.
User-preset States: correspond to the 10 state files stored in internal memory.
Press Utility Preset to select “Default” or one of “User1” to “User10”. Press
Preset at the front panel under any state to switch the instrument to the specified
state. Note that before selecting “User1” to “User10”, make sure that valid state
file is stored in the corresponding storage location.
Table 10-1 Factory Default Values
To Next Page
Loading...
