Rigol DG4000 Series

RIGOL Chapter 3 Arbitrary Waveform Output
DG4000 Series User’s Guide
3-16
2) Press Execute to apply the setting of step 1). The waveform editor will
connect point 1 (level is -2 V) to point 2 (level is 4 V), point 2 to point 4
as well as point 4 to point 1 using straight lines.
3) After finishing editing all the points, press to return to the previous
menu. At this point, press Save to enter the file storage interface (refer to
Store and Recall) to save the edited arbitrary waveform.
7. Observe the edited arbitrary waveform.
3
6
12
2
4
μs
0
4
2
1
-2
V
X1,Y1
9
1
3
X2,Y2
Explanation: as shown in the figure above, the waveform editor will
automatically set the voltage of the last point to that of point 1 to create a
continuous waveform.