Rigol DS1000Z Series User Manual

RIGOL Chapter 8 Reference Waveform
DS1000Z User’s Guide
8-2
To Enable REF Function
Press REF in the vertical control area (VERTICAL) at the front panel to enable the
REF function. Note that when the time base is in XY mode, REF function can not be
enabled.
DS1000Z provides 10 reference waveform channels. Press Channel and use to
set the desired reference channel to on or off and a channel icon (for example,
)
of the channel enabled will be display at the left side of the screen grid.
When the REF function is enabled, you can select different color for each reference
waveform, set the source of each reference channel, adjust the vertical scale and
position of the reference waveform and save the reference waveform to internal or
external memory as well as recall it when needed. For details, please refer to the
introductions below.
To Select REF Source
Press Current and use to select any of the reference channels (Ref1 to Ref10)
enabled and then press Source to specify a reference source (CH1-CH4 or MATH)
for this channel.

Rigol DS1000Z Series Specifications

General

Brand	Rigol
Model	DS1000Z Series
Category	Test Equipment
Language	English