Rigol DS1000Z Series User Manual

Chapter 15 Remote Control RIGOL
DS1000Z User’s Guide
15-1
Chapter 15 Remote Control
The oscilloscope can be controlled remotely mainly through the following two
methods.
User-defined programming
Users can program and control the oscilloscope by using the SCPI (Standard
Commands for Programmable Instruments) commands. For more information about
the commands and programming, refer to the Programming Guide.
Use PC software provided by RIGOL or other manufacturers
Users can use the PC software Ultra Sigma of RIGOL, Measurement &
Automation Explorer of NI (National Instruments Corporation) or Agilent IO
Libraries Suite of Agilent (Agilent Technologies, Inc.) to send commands to
control the oscilloscope remotely.
This oscilloscope can communicate with PC through USB and LAN instrument buses.
This chapter will give a detailed introduction of how to use Ultra Sigma to control
DS1000Z remotely through various interfaces. For the Ultra Sigma software, please
contact RIGOL salesmen or technical support.
The contents of this chapter:
 Remote Control via USB
 Remote Control via LAN

Rigol DS1000Z Series Specifications

General

Brand	Rigol
Model	DS1000Z Series
Category	Test Equipment
Language	English