Rinstrum 5200

Rinstrum - 5200 Communications Manual Rev 1.2
Page 46 0025-605-120
2.4.34. SER: Set Serial Communications Settings
This is used to set the serial mode settings for each serial port.
General Details
No. of Parameters Save Changes Changes Used Increment Trade Counter
7 With TDD1 Immediately No
Parameter Details
Parameter Description Range Default Required
1 Port Number 0
1
Serial 1
Serial 2
- Yes
Serial 1 Serial 2 2 Mode
0
1
2
3
OFF
ON (low)
ON (high)
Network
0
1
OFF
ON (low)
0 No
3 Format
(ON modes
only)
0
1
2
3
4
5
6
7
8
Auto A
Auto B
Auto C
Auto D
Auto E
Print A
Print B
Print C
Custom
0 No
4 Auto source 0
1
2
3
Displayed Reading
Gross Reading
Net Reading
Full Display
0 No
5 Auto Start
Character
0 to 255 (ASCII code) 2 No
6 Auto End
Character 1
0 to 255 (ASCII code) 3 No
7 Auto End
Character 2
0 to 255 (ASCII code) 0 No
Example
Command Response Details
S01; Select Instrument 1
SER?1; 1,0,0,0,2,3,0 CRLF Query Serial 2 settings
SER1,1,5; 0 CRLF Set for Print Format A
TDD1; 0 CRLF Save Setting