60 ProSYS User's Manual
Quick
Key
Function Description
2 Activities
1 Utility Output Allows user control of previously designated external
devices (e.g. an appliance, a motor-driven garage door,
etc.), as described on page 32.
2 Switch
Auxiliary
Interrupts the power supplied to the system's smoke
detector(s) for a predetermined interval, thus resetting and
"readying" them for subsequent alarms, as described on
page 29.
3 Terminate
FM
If Follow Me Destination(s) were chosen, their operation
can be terminated. Use this function when an alarm has
been tripped and there is no need to utilize the Follow Me
feature.
4 Initiate Call By initiating a call to your Monitoring Station, this allows
them to perform a remote programming operation on your
system.
5 Hand Over Similar in intent to Initiate Call (above), Hand Over allows
your Monitoring Station to call you and, during the call,
"hand over" to them the control of your security system.
6 Void Rep
Prg
For installer use only.
Some protocols have a report code to the monitoring
station for entering and exiting the installer programming.
To avoid the entering report and save time, this function
postpones the report for two minutes during which the
installer can enter the programming menu and no report
will be made.
7 Follow Me Allows the entry and/or editing of follow me destinations
used with the Follow-Me feature. In case of an alarm, your
system will generate a telephone call to a designated
system phone or pager, send a sms/email, and, when
connected to the Voice module, employ voice messages to
announce the event that has occurred.
Refer to page 34 for details about editing Follow Me
destinations.
8 Enable U/D Each time this function is enabled, your Monitoring Station
may subsequently gain a single remote access to your
system to make any required programming changes.
Contact your dealer for additional information.
9 Del Rmt Msg Deletes a message that has been sent to the LCD from the
Upload/Download software.
To Next Page
Loading...
