Robe RoboSpot Base Station - Page 27

27
Fixtures cannot stay directly on the stage oor. They have to be placed above the stage oor in two positions
only: head downwards or head upwards.
Fixture bases should be be aligned on the truss.
The plane of xture´s hanging and the plane
of the stage have to be parallel in relation
to each other if you use only two position
points in the MDC setup.
The stage oor can be slanting if you use
three and more position points in MDC
setup.
Small imprecisions of fixture´s
hanging in the horizontal plane
can signicantly a󰀨ect resulting
movement of xtures.
Fixture bases have to be alligned.
in a horizontal plane.
There should not be a deection of
xtures bases in a relation to each
other and to the stage.