Robe RoboSpot Base Station - RoboSpot RDM Device Discovery; RoboSpot System Settings

63
If you select option the Yes, collision xtures will be automatically readdressed.
If you select No, DMX addresses wil stay without change.
6.6 Menu DMX In/Out
After entering the menu item all channels from a current DMX universe are displayed and can be browsed by
touching the keys UP/DOWN. DMX value for every channel is displayed in the table.
Channel 1 Channel 2 Channel 3
Example: +0 +1 +2
1 000 000 000
4 000 000 000
7 000 000 000
In case that value coming via Ethernet and value going to xtures (e.g. Robin BMFL FollowSpot) are not the
same at certain channel , both values are displayed in the following order: value from Ethernet/ value to the
xture (e.g. 190/120).
6.7 Menu Product IDs
Select this menu item to read an RDM UID, MAC Address and RDM Label.
6.8 Menu Software Version
Select this item to read the software version of the xture modules:
Display System - a display processor
Module C - a control panel processor
Module RPI - a control computer in the xture base
6.9 Menu Settings
The menu allows you to set the behaviour of the RoboSpot according to your needs.
System Test - the menu allows you to test jog-wheels, faders and pan/tilt movement of the RoboSpot.
Ethernet Settings - the menu allows you to set the RoboSpot for the Ethernet operation
Ethernet Mode
Artnet - Fixture receives Artnet protocol
gMAI - Fixture receives MANet I protocol
gMA2 - Fixture receives MANet 2 protocol
sACN - Fixture receives sACN protocol
IP Address/Net Mask - select this menu to set IP address. IP address is the Internet protocol
address.The IP uniquely identies any node (xture) on a network.
There cannot be 2 xtures with the same IP address on the network!
Default IP Address -Preset IP address, you can set up only rst byte of IP address
(2 or 10) e.g. 002.019.052.086.
Custom IP Address - The option enables to set up all bytes of IP address.
Net Mask - The option enables to set up all bytes of Net Mask.
ArtNet Universe - use this item to set a Universe (0-255). The Universe is a single DMX
512 frame of 512 channels.
MANet Settings - use this menu to set parameters for MANet operation.
MANet Universe I/II - The value of this item can be set in range 1-256.
MANet Session ID - The value of this item can be set in range 1-32.
sACN Settings - use this menu to set parameters for sACN operation.
sACN Universe - The value of this item can be set in range 1-32000.