Robe RoboSpot Base Station - RoboSpot Maintenance and Cleaning; Replacing the Fuse

68
10. Maintenance and cleaning
DANGER !
Disconnect from the mains before starting any
maintenance work
A soft lint-free cloth moistened with cleaning uid is recommended, under no circumstances should solvents
be used! For cleaning of the LCD monitor use a uid intended for this purpose.
Never use solvents for cleaning the device
More complicated maintenance and service operations are only to be carried out by authorized distributors.
10.1 Replacing the fuse
Replace the fuse by a fuse of the same type and rating only.
Before replacing the fuse, unplug mains lead!
1) Remove the fuse holder on the rear panel of the base with a tting screwdriver from the housing (anti-clockwise).
2) Remove the old fuse from the fuse holder.
3) Install the new fuse in the fuse holder (only the same type and rating).
4) Replace the fuse holder in the housing and x it.
10.2 Disposing of the product
To preserve the environment please dispose or recycle this product at the end of its life according to the local
regulations and codes.
Specications are subject to change without notice.
Copyright © 2017-2022 Robe Lighting - All rights reserved
January 12, 2022
Made in CZECH REPUBLIC by ROBE LIGHTING s.r.o. Palackeho 416/20 CZ 75701 Valasske Mezirici