Roberts Stream 67 - Configuration; Plugging in and language selection

10
Conguration.
Smart Audio System
Internet Radio/DAB/DAB+/FM RDS/Bluetooth/CD/USB
Conguration
Plugginginandlanguageselection
Your audio system may be congured using either the display and buttons on the audio
system, or by using the UNDOK app.
1. Place your audio system on a at surface and plug the mains lead into the mains
socket located at the rear of the audio system ensuring that the plug is pushed fully
into the socket.
2. If you wish to use a wired network connection, plug the Ethernet cable into the RJ-45
socket at the rear of the audio system.
3. Plug the other end of the mains lead into a wall socket and switch on the socket.
IMPORTANT: The mains plug is used as the means of connecting the audio system
to the mains supply. The mains socket and any multi-way mains block used for the
audio system must remain accessible during normal use. In order to disconnect the
audio system from the mains, the mains plug should be removed from the mains
socket outlet completely.
4. When you apply power, the display on the audio system will light up and show a
start up screen for a few seconds.
If this is the rst time that you use your audio system (or after a Factory Reset) the
display will show the language menu.
5. By default your audio system will display all menus and messages in English. Press
Menu Up or Down to highlight the desired language. Press Select to enter the
selection. 'Setup wizard' and 'YES' will be highlighted on the screen.
Note: If you wish to use UNDOK to setup your audio system, please see
page18.
6. If you would like to setup your audio system using the audio system's controls instead
of the UNDOK app then press Select to select 'YES' and to begin setting up your
audio system.
Continue on the next page.
Setup wizard
Start now?
English
Dansk
Nederlands
Français
Deutsch
Italiano
Language
*
DAB
30