Roberts Stream 67 - Playing a CD

55
InsertingaCD
Ensure the CD player is empty before inserting a disc. If you cannot insert a disc,
applyalongpress on the CD Eject button (on the top panel of the unit) to remove
the CD currently in the player.
1. Press the On / Standby button to switch on your audio system.
2. To select the CD mode press the Mode button until 'CD' shows on the display
or insert an audio CD.
3. To eject a CD applyalongpress on the CD Eject button. To reload a CD that
has just been ejected, applyalongpress on the Eject button.
4. Insert a disc with printed side facing up into the CD slot. The disc will be loaded
automatically. The unit will check the CD type and load its track list. The display
will show 'Loading' and then 'Reading' as the information is read.
5. If you load a disc containing MP3 or WMA les your audio system will enter the
MP3 / WMA mode.
PlayingaCD
1. Press the Play / Pause button to start playing the disc. Audio CD - the display
will show the rst track number. MP3/WMA CD - the display will show the rst
folder and le numbers.
2. Adjust the Volume to the required setting.
3. To pause playing press the Play / Pause button. To resume play press the Play
/ Pause button again.
4. To stop playback, press the Stop button.
5. If you put the unit into standby mode then the next time the unit is switched on
it will return to the previously played track.
CD
12:34
Reading
CD
12:34
T001 00:15
Playing
CD
12:34
T001 00:15
Pause
CD
12:34
T015 64:44
Stop
DAB
30