Robin R1210 Brushless - Page 41

Step
13.
I
i
‘art to remove
Rotor
!
t-
t
i
Fig. 10-23
(2) Put the engine on the working table
recoil slarter side down.
(3) Use a bolt and oil as a rool for pulling
out rotor in the follo\ving procedures :
1. Pour engine oil into the center hole of
rotor shaft.
I
Fill with oil to the shaft end.
(See Fig. 10-24.)
2. Prepare a bolt with the following
thread size : M8 X P 1.25
3. Apply a few turns of seal tape around
the tip of the bolt.
(See Fig. 10-25.)
!
Descrlptlon Remarks
(1) Take off the through bolt.
Apply a box wrench on the head of
through bolt. Hit the wrench handle with
a hammer counter-clockwise to loosen.
I
Tool
Box wrench
Plastic hammer
Fig. 70-24
Fig. 1 O-25
- 35 -