Robotics V3 User Manual

How to Build the Robotics++ V3 Robot
1

Robotics V3 Specifications

General

Weight	2.5 kg
Operating Voltage	12V
Sensors	Ultrasonic, Infrared, Gyroscope
Connectivity	Bluetooth, Wi-Fi
Programming Language	Python
Material	ABS Plastic, Aluminum

Summary

Step 1: Servo Motor Assembly

Inserting Motors into Servo Holders

Detailed steps for mounting servo motors into their holders.

Servo Shaft Orientation

Guidance on correct servo shaft orientation for assembly.

Step 2: Servo Holder L Bracket Assembly

Attaching L Brackets to Servo Holders

Detailed procedure for attaching L brackets, noting screw direction and alignment.

Plastic L Bracket Installation

Step 3: Line Following Sensor Assembly

Mounting the Line Following Sensor

Detailed steps and visual guide for attaching the line following sensor.

Front Acorn Nut Installation

Step 4: Feeler Sensor Assembly

Attaching Feeler Switches

Step 5: Servo Motor Mounting on Lower Chassis

Attaching Servo Motors with Spacers

Step 6: Electrical System Integration

Arduino, Battery Holder, and Sensor Shield Wiring

Overview of connecting Arduino, battery holder, and sensor shield.

Battery Holder Preparation and Switch Wiring

Step 7: Battery Holder and Back Acorn Nut Assembly

Step 8: Upper Chassis and Arduino Board Assembly

Mounting Arduino Board on Upper Chassis

Step 9: Sensor Shield Verification

Mounting the Arduino Sensor Shield

Step 10: Breadboard Mounting

Step 11: Battery Installation

Step 12: Upper Chassis Installation

Step 13: Battery Switch and Power Connections

Connecting Battery to Sensor Shield

Wiring battery power to the Arduino Sensor Shield.

Step 14: Wheel Assembly

Step 15: Infrared Sensor Mounting

Step 16: Micro Servo and Sonar Sensor Mounting

Attaching Micro Servo and Sonar Sensor