RockShox PIKE - Page 51

51
Damper Bleed
Fully extend the rebound damper shaft. Push the syringe plunger Fully extend the rebound damper shaft. Push the syringe plunger
down, then release the plunger. Allow the bladder to expand and down, then release the plunger. Allow the bladder to expand and
retract until it stops in a resting position.retract until it stops in a resting position.
Unthread the syringe bleed fitting from the bleed port.Unthread the syringe bleed fitting from the bleed port.
⚠ CAUTION
Oil may eject from the bleed port if the bladder is not in a resting
position. Wear safety glasses.
Install the bleed screw and tighten it.Install the bleed screw and tighten it.
Wipe away any excess oil.Wipe away any excess oil.
4
5
6
T10 1.7 Nm (15 in-lb)