RockShox PIKE - 200 Hour Service Control Module Installation

59
Control Module Installation
200 Hour Service Control Module Installation
The keyed ends of the Control Module output driver and the The keyed ends of the Control Module output driver and the
compression damper adjuster must be aligned in the same orientation compression damper adjuster must be aligned in the same orientation
before installation. before installation.
NOTICE
Confirm the inside of the top cap is clean before installing the
Flight Attendant Control Module. Contamination will affect the
compression damper seal and function of the Control Module.
Check key alignment before installation. If the keys are not aligned, Check key alignment before installation. If the keys are not aligned,
rotate the adjuster key on the Control Module output driver to the rotate the adjuster key on the Control Module output driver to the
same orientation as the adjuster key in the compression damper.same orientation as the adjuster key in the compression damper.
1
Flat blade screwdriver