RockShox PIKE - Service and Maintenance Guidance; Recommended Service Intervals; Torque Specifications

7
Recommended Service Intervals
Recommended Service Intervals
Regular service is required to keep your RockShox product working at peak performance. Follow this maintenance schedule and install the service
parts included in each service kit that corresponds with the Service Hours Interval recommendation below. For spare part kit contents and details,
refer to the RockShox Spare Parts Catalog at www.sram.com/service.
Service Hours Interval Maintenance Benefit
Every ride Clean dirt from upper tubes and wiper seals
Extends wiper seal lifespan
Minimizes damage to upper tubes
Minimizes lower leg contamination
Every 50 hours Perform lower leg service
Restores small bump sensitivity
Reduces friction
Extends bushing lifespan
Every 200 hours Perform damper and spring service
Extends suspension lifespan
Restores small bump sensitivity
Restores damping performance
Record Your Settings
Use the table below to record your suspension settings to return your suspension to its pre-service settings. Record your service dates to track
service intervals.
Service Hours Interval Date of Service Air Pressure
Rebound setting - Count the
number of clicks while turning
the rebound adjuster fully
counter-clockwise.
50
100
150
200
Torque Values
Part Tool Torque
Bleed screw - rebound damper seal head TORX T10 1.7 N•m (15 in-lb)
Bottom bolt - air spring and damper 5 mm hex bit socket 6.8 N•m (60 in-lb)
Bottomless Tokens 8 mm hex 4 N•m (35 in-lb)
ButterCup housing shaft end plate - end plate to shaft - air and damper TORX T25 3.3 N•m (29 in-lb)
Seal head - rebound damper to damper cartridge tube 23 mm crowfoot 5 N•m (45 in-lb)
Set screw (x2) - Flight Attendant Control Module to compression damper
top cap
2 mm hex bit socket 0.25 - 0.5 N•m (2.2 - 4.3 in-lb)
Set screw - rebound adjuster knob 2.5 mm hex bit socket 0.84 N•m (7.5 in-lb)
Top cap - air spring
RockShox Top Cap/Cassette Tool
(or standard cassette tool)
28 N•m (250 in-lb)
Top cap - compression damper
27 mm socket (optional)
Upper ButterCup housing to lower ButterCup housing - air and damper 25 mm crow foot 3.3 N•m (29 in-lb)