RockShox PIKE - 200 Hour Service Air Spring Installation

35
Air Spring Installation
200 Hour Service Air Spring Installation
Apply a liberal amount of SRAM Butter grease evenly around the end Apply a liberal amount of SRAM Butter grease evenly around the end
of a clean plastic dowel, approximately 150 mm from one end. Use of a clean plastic dowel, approximately 150 mm from one end. Use
the dowel to apply the grease to the inside surface of the upper tube, the dowel to apply the grease to the inside surface of the upper tube,
approximately 150 mm into the tube.approximately 150 mm into the tube.
Apply grease to the air piston and seal head outer o-rings.Apply grease to the air piston and seal head outer o-rings.
With the crown steerer upper tube assembly clamped in the bicycle With the crown steerer upper tube assembly clamped in the bicycle
work stand, orient the upper tubes upward and the steerer tube work stand, orient the upper tubes upward and the steerer tube
oriented downward.oriented downward.
Insert the air spring assembly into the upper tube. Firmly push the air Insert the air spring assembly into the upper tube. Firmly push the air
piston into the upper tube.piston into the upper tube.
Inject 1 mL of Maxima PLUSH Dynamic Suspension Lube into the upper Inject 1 mL of Maxima PLUSH Dynamic Suspension Lube into the upper
tube, on top of the air piston and into the negative air chamber.tube, on top of the air piston and into the negative air chamber.
1
Dowel and grease 150mm
2
SRAM Butter Grease
3
1 mL PLUSH Dynamic Suspension Lube