24 Publication 2711C-UM001C-EN-P - September 2009
Chapter 2 Configuration Mode
On the C600 and C1000 terminals the default language is set on the
Main menu. Just click the up and down arrows to select the language.
Follow these steps to change the language on the C200 and C300
terminals.
1. Click Config Language.
2. Press F1 to select the language.
The display changes to the language you select immediately.
IMPORTANT
At runtime, diagnostic messages appear in the same language
as the application if the application language is English,
Portuguese, French, Italian, German, Spanish, Chinese, or
Korean. For all other languages, the diagnostic messages
appear in the configuration language set on the terminal.
To Next Page
Loading...
Need help?
General
