20 Rockwell Automation Publication 1756-UM021A-EN-P - September 2023
Chapter 2 Configure the Module with Studio 5000 Logix Designer
FactoryTalk Optix Studio You can use the FactoryTalk® Optix Studio™ software to configure and program the
application for the Edge Compute module. FactoryTalk Optix Studio can be installed as a
desktop application or run in the cloud within a web browser.
Restart Select Restart to restart the device. A prompt appears asking if you want to restart the device.
If the project is offline, no online data is shown.
Parameter Description
From WEB Opens FactoryTalk Optix Studio software from the cloud in a web browser.
From installed application
Opens FactoryTalk Optix Studio software from the application that is installed on
your computer. You can only launch the desktop application is only enabled when
the software is installed on the local machine.
Button Description
Restart
Restarts the operating system on the module. This powers off and reboots the
module.
To Next Page
Loading...
Need help?
General
