28 Rockwell Automation Publication 1756-UM021A-EN-P - September 2023
Chapter 3 System Manager
Date and time
Time synchronization mode
This combo box enables you to configure your device's date and time settings.
• Auto (PLC) synchronizes the date and time automatically with a ControlLogix® controller.
• Auto (Remote NTP server) synchronizes the date and time automatically with a remote
Network Time Protocol (NTP) server.
Auto PLC
Visible only when the Time synchronization mode is Auto (PLC), allowing to set the slot number
of the ControlLogix Controller with this syntax:
Backplane\slot number
For example, if the Logix Controller is at slot 0: Backplane\0
Remote NTP Server
Visible only when the Time synchronization mode is Auto (Remote NTP server), allowing to set
the IP address of the NTP server.
Date/Time/Time Zone
Displays the synchronized date and time.
The device can be configured to automatically adjust the date and time from a
remote NTP server and provide the same service to connected devices (local NTP
server).
To Next Page
Loading...
Need help?
General
