Summary of Changes
Manual Updates
Current Revision
This information summarizes the changes made to the PowerFlex
®
700S
and 700H Drives Frame 10 - Hardware Service Manual, publication
PFLEX-TG002..., since the April 2007 release.
Previous Revision
This information summarizes the changes made to the PowerFlex
®
700S
and 700H Drives Frame 10 - Hardware Service Manual, publication
PFLEX-TG002..., since the July 2005 release.
Change See Page...
Updated the 700S and 700H faults. 1-2
Removed the “Diagnostic Procedures by Symptom” diagrams and replaced them with
the new “Common Drive Conditions and Corrective Actions” tables.
1-17
Added the “Technical Support Options” section. 1-19
Removed the “Active” Gate Driver Board measurements procedures from Chapter 2.
Updated the “Checking the Rectifying Module” procedures to include the new Series B
Rectifying board.
2-9
Added procedure for removing the precharging resistors on series B rectifiers. 3-32
Updated the “Start-Up After Repair” procedures. 4-1
Updated the “Right-Hand Side” and “Left-Hand Side Power Structure” spare parts lists. C-4
Change See Page...
Updated the 700S hardware faults 1-2
Removed references to brake option in the “Conducting Forward and Reverse Biased
Diode Tests for Major Power Components” (brake option not available on PowerFlex
700H/S Frame 10 drives)
2-3
Added Removal of PowerFlex 700S Phase II Control 3-6
Added the Removal of the Common Mode Filter Board 3-9
Updated the Circuit Board Connections Schematics to include the X50 Terminal Block
and Common Mode Filter circuit board
B-1
Updated the Spare Parts Lists for the Disassembly / Assembly Drawings C-1
Added an Index Index-1
To Next Page
Loading...
Need help?
General
