Chapter 4
Start-Up After Repair
Loading the 700H EEPROM
If you replace the Output Power Modules or Control Board in a 700H drive
you must load information about the Power Modules or Control Board into
the Power EEPROM. Contact Allen-Bradley Drives Technical Support for
instructions and software tools for performing this operation.
Be prepared to provide the following information when you contact
technical support:
• Product Catalog Number
• Product Serial Number
• Firmware Revision Level
!
ATTENTION: Power must be applied to the drive to perform
the following start-up procedure. Some of the voltages present
are at incoming line potential. To avoid electric shock hazard or
damage to equipment, only qualified service personnel should
perform the following procedure. Thoroughly read and
understand the procedure before beginning. If an event does not
occur while performing this procedure, Do Not Proceed. Remove
Power including user supplied control voltages. User supplied
voltages may exist even when main AC power is not applied to
then drive. Correct the malfunction before continuing.
Phone United States/
Canada
1.262.512.8176 (7 AM - 6 PM CST)
1.440.646.5800 (24 hour support)
Outside United
States/Canada
You can access the phone number for your country via
the Internet:
Go to http://www.ab.com
Click on Support (http://
support.rockwellautomation.com/)
Under Contact Customer Support, click on Phone
Support
Internet ⇒ Go to http://www.ab.com/support/abdrives/
E-mail ⇒ support@drives.ra.rockwell.com
To Next Page
Loading...
Need help?
General
