What to do if Rockwell Controller shows a Non-Resettable Fault?
A Non-Resettable Fault typically indicates a need for drive or motor repair. Before the fault can be cleared, the underlying cause must be addressed. After the repair, the fault will be reset when the power is turned on.
How to manage User Configurable Faults on a Rockwell PowerFlex 70?
User Configurable Faults can be enabled or disabled, allowing you to choose whether to be notified of or ignore a fault condition.
How to manage User Configurable Alarm on Rockwell Controller?
User Configurable Alarms can be enabled or disabled via [Alarm Config 1].
Important factors regarding the AC power supply for the drive.
Procedures for proper grounding of the drive and associated components.
Recommendations and requirements for input protection devices.
Detailed guidance on connecting input/output signals to the drive.
Guidelines for ensuring electromagnetic compatibility of the drive installation.
Parameters related to motor configuration and control.
Parameters for setting drive speed references and limits.
Parameters for ramp rates, load limits, and braking.
Parameters for configuring drive digital and analog I/O.
Overview of fault and alarm types and their descriptions.
Step-by-step guide for clearing drive faults.
Detailed descriptions and actions for specific drive faults.
Detailed descriptions and actions for specific drive alarms.
Troubleshooting guide for common drive issues and their solutions.
Recommended ratings for AC line input fuses and circuit breakers.
Step-by-step guide for accessing and modifying drive parameters via HIM.
General| Model | PowerFlex 70 |
|---|---|
| Output Voltage | 0 to Input Voltage |
| Horsepower Range | 0.5...25 Hp |
| kW Range | 0.37...18.5 kW |
| Output Current | Varies by model and voltage |
| Amperage | Varies by model and voltage |
| Communication Protocols | DeviceNet, ControlNet, EtherNet/IP |
| Enclosure Type | IP20, IP30 |
| Dimensions | Varies by frame size |
| Storage Temperature | -40°C to 70°C (-40°F to 158°F) |
| Relative Humidity | 5% to 95% non-condensing |
| Altitude | 1000m (3300 ft) without derating |
| Input Voltage | 200-240VAC, 380-480VAC, 500-600VAC |
| Power Range | 0.4 to 22 kW (0.5 to 30 HP) |
| Power Rating | 0.5...25 Hp / 0.4...18.5 kW |
| Control Method | Voltage/Frequency (V/F), Sensorless Vector, Flux Vector |
To Next Page
