R&S M3SR Series 4100 HF Transceivers Frontend - Removal and Installation
6124.9007.82.01 5.12
Fig. 5.6 Removing the Frontend (A1)
1 Frontend (A1)
2 Connector X1
3 Connector X2 (cable W2111, not connected if Digital Selector is fitted)
4 Cable W231
5 Cable W11
6 Connector X3
7 Cable W12
8 Connector X4
5.5.2 Installation of Frontend (A1)
To install a new or repaired Frontend (A1) proceed as follows:
1. Install the Frontend (A1) in reverse order of removal.
2. Close the R&S M3SR Series 4100 150 W HF Transceiver in reverse order as described in
5.1 - Disassembly.
ICN-S4100-A-E11100-R-D0894-00115-A-01-1
1
2
3
4
5
6
7
8
To Next Page
Loading...
