Interface Module - Removal and Installation R&S M3SR Series 4100 HF Transceivers
5.21 6124.9007.82.01
Fig. 5.12 Removing the Interface Module
1 Connector X301
2 Cable W2111 (if the FK 41x0 Digital Selector is installed)
3 Screws (8x)
4 Interface Module
5.9.2 Installation of Interface Module
To install a new Interface Module proceed as follows:
1. Install the Interface Module in reverse order of removal.
2. Close the R&S M3SR Series 4100 150 W HF Transceiver in reverse order as described in
5. - Disassembly.
3. Install any module plugged in the Interface Module (e.g. R&S GS 4102 NMEA Interface).
x8
ICN-S4100-A-E11100-R-D0894-00122-A-01-1
1
2
3
4
To Next Page
Loading...
