Rohde & Schwarz M3SR Series 4100 - Front Panel - Removal and Installation; Removal of Front Panel (A10); Fig. 5.13 Removing the Front Panel (A10)

R&S M3SR Series 4100 HF Transceivers Front Panel - Removal and Installation
6124.9007.82.01 5.22
5.10 Front Panel - Removal and Installation
5.10.1 Removal of Front Panel (A10)
To remove the Front Panel (A10) from the R&S M3SR Series 4100 150 W HF Transceiver proceed as
follows (see also
Fig. 5.13):
1. Take off the bottom cover of the R&S M3SR Series 4100 150 W HF Transceiver as described in
5.1 - Disassembly.
2. Disconnect the ribbon cable W30 from connector X260 at the Motherboard.
3. If installed, remove the R&S GB 4000C Comfort Control Unit from the R&S M3SR Series 4100
150
W HF Transceiver as described in 5.8 - Removal and Installation.
4. Undo and remove the twelve screws fixing the Front Panel (A10) to the chassis.
5. Carefully pull the Front Panel (A10) to the front and off.
Fig. 5.13 Removing the Front Panel (A10)
ICN-S4100-A-E11100-R-D0894-00123-A-01-1