Rohde & Schwarz M3SR Series 4100 - NMEA Interface - Removal and Installation; Removal of the R&S GS 4102 NMEA Interface; Installation of the R&S GS 4102 NMEA Interface; Fig. 5.19 Removing the R&S GS 4102 NMEA Interface

NMEA Interface - Removal and Installation R&S M3SR Series 4100 HF Transceivers
5.29 6124.9007.82.01
5.14 NMEA Interface - Removal and Installation
5.14.1 Removal of the R&S GS 4102 NMEA Interface
To remove the R&S GS 4102 NMEA Interface from the R&S M3SR Series 4100 150 W HF Transceiver
proceed as follows (see also
Fig. 5.19):
1. Using a screw driver, unscrew the two screws at the R&S GS 4102 NMEA Interface.
2. Carefully pull the R&S GS 4102 NMEA Interface out to the back of the R&S M3SR Series 4100
150
W HF Transceiver.
Fig. 5.19 Removing the R&S GS 4102 NMEA Interface
5.14.2 Installation of the R&S GS 4102 NMEA Interface
To install a new R&S GS 4102 NMEA Interface proceed as follows:
1. Install the R&S GS 4102 NMEA Interface in reverse order of removing.
ICN-S4100-A-E11100-R-D0894-00129-A-01-1