Rohde & Schwarz ZNB40 - Control<Ch>:Rffe<Bus>:Settings:voltage:io; Control<Ch>:Rffe<Bus>:Test:vio

Command Reference
R&S
®
ZNB/ZNBT
1017User Manual 1173.9163.02 ─ 54
CONTrol<Ch>:RFFE<Bus>:TEST:DATA:RANGe <Data Current Range>
CONTrol<Ch>:RFFE<Bus>:TEST:CLOCk:RANGe <Clock Current Range>
CONTrol<Ch>:RFFE<Bus>:TEST:VIO:RANGe <CurrentRange>
Defines the (upper bound of the) current range for the voltage/current measurement on
the respective RFFE pin. The analyzer firmware automatically selects a suitable shunt
resistance, which can be queried using CONTrol<Ch>:RFFE<Bus>:TEST:VIO:
SHUNt?.
Suffix:
<Ch>
.
Channel number
<Bus> RFFE bus interface 1 or 2
Parameters:
<CurrentRange> Range:
2 x 10
n
μA with n=1,...,5
Default unit: A
Example: see CONTrol<Ch>:RFFE<Bus>:TEST:VIO:SHUNt?
on page 1017
Options: R&S ZN-B15/Z15 Var. 03
Manual operation: See "Range / Shunt" on page 520
CONTrol<Ch>:RFFE<Bus>:TEST:CLOCk:SHUNt?
CONTrol<Ch>:RFFE<Bus>:TEST:DATA:SHUNt?
CONTrol<Ch>:RFFE<Bus>:TEST:VIO:SHUNt?
Returns the shunt resistance (in Ω) selected by the analyzer firmware for the config-
ured current range (see CONTrol<Ch>:RFFE<Bus>:TEST:VIO:RANGe).
The dependency between current range and shunt resistance is displayed in the table
below.
Suffix:
<Ch>
.
Channel number
<Bus> RFFE bus interface 1 or 2
Example:
:CONTrol1:RFFE1:TEST:DATA:RANGe 20.0mA
:CONTrol1:RFFE1:TEST:CLOCk:RANGe 2mA
:CONTrol1:RFFE1:TEST:VIO:RANGe 0.2mA
:CONTrol1:RFFE1:TEST:DATA:SHUNt?
Returns 10 [Ω]
:CONTrol1:RFFE1:TEST:VIO:RANGe 2mA
:CONTrol:RFFE1:TEST:CLOCk:SHUNt?
Returns 100 [Ω]
:CONTrol1:RFFE1:TEST:VIO:RANGe 0.2mA
:CONTrol:RFFE1:TEST:VIO:SHUNt?
Returns 1000 [Ω]
Usage: Query only
Options: R&S ZN-B15/Z15 Var. 03
SCPI Command Reference