Command Reference
R&S
®
ZNB/ZNBT
995User Manual 1173.9163.02 ─ 54
Example:
*RST; :CONF:CHAN:TRAC:REN 'Testtrace_1'
Reset the analyzer to create a default trace in channel 1 and set
this trace as the active trace. Rename the trace 'Testtrace_1'.
CALC:PAR:SDEF 'Testtrace_2', 'S11'
Create a new trace which will become the active trace in chan-
nel no. 1.
CONF:TRAC:REN 'Testtrace_1', 'Testtrace_3'
Rename the first trace (which is currently not active) 'Test-
trace_3'.
Usage: Setting only
Manual operation: See "Table Area" on page 307
CONFigure:CHANnel<Ch>:TRACe:CATalog?
Returns the numbers and names of all traces in channel no. <Ch>. The response is a
string containing a comma-separated list of trace numbers and names; see example. If
all traces have been deleted the response is an empty string ("").
Tip: Use CONFigure:TRACe:CATalog? to query the traces in all channels of the
active recall set.
Suffix:
<Ch>
.
Channel number
Example: See CONFigure:TRACe:CATalog?
Usage: Query only
Manual operation: See "Table Area" on page 307
CONFigure:TRACe:CATalog?
Returns the numbers and names of all traces in the current recall set. The response is
a string containing a comma-separated list of trace numbers and names, see example
below. If all traces have been deleted the response is an empty string ("").
Tip: Use CONFigure:CHANnel<Ch>:TRACe:CATalog? to query the traces in a par-
ticular channel; see example.
SCPI Command Reference
To Next Page
Loading...
