Rohde & Schwarz ZNB40 - Table of Contents

GUI Reference
R&S
®
ZNB/ZNBT
700User Manual 1173.9163.02 ─ 54
Remote Encoding
Selects the character encoding used at the remote interface. The selected encoding
applies to directory and file names, calibration kit names, calibration unit characteriza-
tions and display titles.
Currently the following encodings are supported: ANSI (default), UTF-8, Shift JIS.
Remote command:
SYSTem:COMMunicate:CODec
6.17.1.2 System Config Dialog
The "System Config" dialog allows you to define global settings that are not affected by
an instrument reset. See Chapter 5.1.1, "Global (Persistent) Settings", on page 81.
Access: SYSTEM – [SETUP] > "Setup" > "System Config..."
● Presets Tab........................................................................................................... 700
● Calibration Tab...................................................................................................... 702
● User Interface Tab.................................................................................................704
● Messages Tab.......................................................................................................706
● Channel Bits Tab...................................................................................................707
● Advanced Tab....................................................................................................... 708
● Power Tab............................................................................................................. 709
● Recovery Tab........................................................................................................ 711
Presets Tab
Specifies the behavior of the R&S ZNB/ZNBT upon a preset.
Setup Softtool