Rohde & Schwarz ZNB40 - Calculate:transform

Command Reference
R&S
®
ZNB/ZNBT
928User Manual 1173.9163.02 ─ 54
Manual operation: See "TD-VSWR" on page 321
8.3.1.20 CALCulate:TRANsform...
The CALCulate:TRANsform... commands convert measured data from one repre-
sentation to another and control the transformation into the time domain (see Chap-
ter 5.7.2, "Time Domain Analysis", on page 203).
CALCulate<Chn>:TRANsform:COMPlex.......................................................................... 928
CALCulate<Chn>:TRANsform:IMPedance:RNORmal........................................................ 929
CALCulate<Chn>:TRANsform:TIME[:TYPE]..................................................................... 929
CALCulate<Chn>:TRANsform:TIME:CENTer.................................................................... 930
CALCulate<Chn>:TRANsform:TIME:DCHebyshev............................................................ 930
CALCulate<Chn>:TRANsform:TIME:LPASs......................................................................931
CALCulate<Chn>:TRANsform:TIME:LPASs:DCSParam.....................................................931
CALCulate<Chn>:TRANsform:TIME:LPASs:DCSParam:CONTinuous................................. 932
CALCulate<Chn>:TRANsform:TIME:LPASs:DCSParam:EXTRapolate................................ 932
CALCulate<Chn>:TRANsform:TIME:LPFRequency........................................................... 933
CALCulate<Chn>:TRANsform:TIME:RESolution:EFACtor.................................................. 933
CALCulate<Chn>:TRANsform:TIME:SPAN....................................................................... 933
CALCulate<Chn>:TRANsform:TIME:STARt...................................................................... 934
CALCulate<Chn>:TRANsform:TIME:STATe...................................................................... 934
CALCulate<Chn>:TRANsform:TIME:STIMulus..................................................................935
CALCulate<Chn>:TRANsform:TIME:STOP.......................................................................935
CALCulate<Chn>:TRANsform:TIME:WINDow...................................................................935
CALCulate<Chn>:TRANsform:TIME:XAXis.......................................................................936
CALCulate<Chn>:TRANsform:COMPlex <Result>
Converts S-parameters into converted (matched-circuit) Y-parameters or Z-parameters
and vice versa, assuming that port no. i is terminated with Z
0i
so that the three parame-
ter sets are equivalent and the following formulas apply:
ii
ii
iii
S
S
ZZ



1
1
0
 
,,2
00
00
jiZZ
S
ZZ
Z
ji
ij
ji
ij



ii
ii
ii
i
ii
Z
S
S
Z
Y /1
1
11
0




 
99...,,1,,,/1
2
0000


 jijiZ
ZZSZZ
S
Y
ij
jiijji
ij
ij
SCPI Command Reference