- 11 -
Loosen the nuts on the width and height adjustment bolts with
the box end wrench.
HEIGHT ADJUSTMENT
Tighten the nuts on the width and height adjustments bolts with
the box end wrench until snug + one-quarter turn. Note: If
torque wrench available, tighten to 42 +/- 2 inch-pounds (4.75
+/- 0.25 Newton-meters).
Slide the back shell up and down in the vertical slots until the
desired height is achieved.
WARNING: Once adjustment is complete, make sure all
hardware is securely tightened.
4
3
21
Install the AGILITY on the wheelchair. See AGILITY
INSTALLATION. The individual may be seated in the chair. See
HEIGHT ADJUSTMENT WARNING at the top of this page.
WARNING: Height adjustments can be made with the individual in the chair if performed with caution. Make sure wheelchair wheels are
locked, AGILITY safety locks are in the LOCKED ( ) position, and all hardware is securely tightened before the individual is seated in
the chair.
IMPORTANT! In the sliding height adjustment bar, count
the number of square slots that are visible through the
vertical slots in the back shell to make sure that the left (L)
and right (R) back shell hardware are in the same position.
To Next Page
Loading...
