ROHO AGILITY - Product Specifications

- 5 -
To order replacement parts: In the U.S.A., contact the ROHO Customer Service Department, call your product provider or visit
www.therohostore.com. Outside the U.S.A., contact your country’s ROHO International distributor.
PARTS DETAIL CONTINUED
PRODUCT SPECIFICATIONS*
Cover Components Detail:
*Note: The air insert and the foam insert are not intended to be used together.
Cover with Foam Pad only
Foam Pad
Cover
Zipper
Handle
Handle
Air Insert
Foam Pad
Cutout area
for air insert
or foam
insert
Valve Hose
Zipper
Cover
Foam Insert
Cover with Foam Pad + Air Insert or Foam Insert*
Fastener
Strip
Handle
Handle
-OR-
-OR-
BACK CANE BRACKET COMPATIBILITY
Back Cane Bracket
(Top View)
Adjusts to Fit Back Cane Diameters (A)
Smallest Largest
in. (cm) in. (cm)
Standard
Fits Circular
Back Canes
0.75 (2.0) 1.0 (2.5)
A
A
*NOTE: All measurements are approximate.
WARNINGS:
AGILITY is compatible with many wheelchairs that are angularly adjustable, recline or tilt and result in a back angle up to and
including 60 degrees. Beyond 60 degrees, AGILITY may not be an appropriate selection. Use with wheelchairs that angularly adjust,
recline or tilt to a back angle greater than 60 degrees may cause AGILITY to accidentally disconnect from the wheelchair, resulting
in a fall and the potential for serious injury. Consult a clinician to determine if AGILITY is compatible with the individual’s wheelchair.
Rigidizer bars may pose a mounting challenge. See TROUBLESHOOTING. Make sure the rigidizer bar does not interfere with any of
the back cane hardware components.
Note: If the back cane brackets are installed on the front side of the back canes, there will be up to 1 in. (2.5 cm) of additional seat depth loss.
Materials:
Cover:
Front Side: Polyester
Back Side: Polyurethane foam coated
nylon/polyurethane coated polyester
Flaps: Polyurethane-coated polyester
Lumbar Support Pad: Polyurethane
Foam Pad:
Front Side: Polyurethane
Back Side: Polyethylene
Foam Insert: Polyurethane
Air Insert:
Front Side: Polyether polyurethane
Back Side: Urethane film coated nylon
Back Shell: Aluminum
Back Shell Hardware: Zytel
®
Sliding Height Adjustment Bar: Aluminum
Back Cane Hardware:
Back Cane Bracket: Aluminum
Pivoting Cane Band and Adjustment
Cylinder: Steel
AGILITY complies with CAL 117, EN 1021-1 and EN 1021-2 flammability requirements.
Wheelchair Compatibility:
AGILITY is designed to be used with most wheelchairs that have back canes described in the BACK CANE BRACKET COMPATIBILITY chart.
AGILITY must be sized correctly to the wheelchair and may not fit every wheelchair. Consult with the provider or clinician providing your
equipment to determine if your wheelchair and back canes are compatible with AGILITY.