Roland EGX-350 - Page 5

Contents
3
Company names and product names are trademarks or registered trademarks of their respective holders.
Copyright © 2007-2012 Roland DG Corporation
http://www.rolanddg.com/
The USB cable came loose during engraving................................................................................................................. 102
7-3 Responding to a Message ................................................................................................103
7-4 Responding to an Error Message .....................................................................................104
Chapter 8 Appendix ......................................................................................................................107
8-1 Examples of Settings for Cutting Parameters ...................................................................108
Example Settings ...................................................................................................................................................................... 108
Tips for Fine-tuning ................................................................................................................................................................. 108
8-2 Location of Power Rating and Serial Number Label ......................................................... 109
8-3 Interface Specications ..................................................................................................... 110
Serial Connector ....................................................................................................................................................................... 110
Expansion Connector .............................................................................................................................................................. 111
8-4 Main Unit Specication ..................................................................................................... 112
Dimensions of Outline ............................................................................................................................................................ 112
Work area ..................................................................................................................................................................................... 113
Workpiece-table Installation-area Dimensional Drawing ......................................................................................... 114
Main Specications .................................................................................................................................................................. 115
System Requirements for USB Connection ..................................................................................................................... 115
Roland DG Corp. has licensed the MMP technology from the TPL Group.