Roland EGX-350 - 4-8 Setting the XY Origin Point

73
Chapter 4 Engraving
4-7 Cutter Installation Method 4 (End mill)
3. Make the settings for spindle speed and Z-axis control.

Press several times to display the screen shown at left.
Use
and to select [OTHERS].
Press
.

Use to select “ON.”
Press
to conrm.

Press .
Use
to select “OFF.”
Press
to conrm.
The message shown at left is displayed for three seconds, and then the original
screen returns.

Press several times to return to the main screen.
4. Set the Z-axis origin point.

Use , , and to move the end mill to a location above the work-
piece.
Next, perform a small amount of cutting into the workpiece. Move to a location where cutting will not cause any
problems.
 P. 44, “Manual Movement”

Close the front cover, then press and hold for at least one second.
The spindle rotates.
 P. 47, “Starting and Stopping Spindle Rotation”

Press to lower the end mill to a
location where the workpiece is cut by
a slight amount.

Press .
The spindle stops.
End mill
Workpiece