Roland F-120 R - Restoring the settings to the factory condition (Factory)

28

Restoring the settings to the factory condition (Factory)
The settings you’ve changed in Function mode can be restored to their
factory-set condition. This operation is called “Factory”.
Note!
The “Factory” operation will erase all settings stored by the
Memory Backup function.
1. While holding down the [Split] and [Transpose] buttons,
turn on the power.
Factory?
NY
If you decide not to execute the Factory Reset operation, press the
[–] button.
2. Press the [+] button to select “Y”.
When the Factory Reset has been completed, the display will
indicate “End.”
* Never turn o the power before the display indicates “End.”
3. Press the [Power] switch to turn the power o, then on
again.