Troubleshooting
30
Symptom Cause/Action Page
Sound wrong, or are buzzy
If you set the volume to the maximum setting, the sound may be distorted depending on how you perform. If this occurs, turn
down the volume.
—
If you don’t hear this in headphones:
Performing at high volumes may cause the speakers or objects near the unit to resonate. Fluorescent lights or glass doors may
also resonate sympathetically. In particular, this is more likely to occur for lower notes and higher volumes. You can take the
following measures to minimize resonances.
• Locate this unit 10–15 cm (4–6 inch) away from walls or other surfaces.
• Keep the volume down.
• Move away from the objects that are resonating.
—
If you hear this in headphones:
It is likely that there is some other reason. Please contact your dealer or a nearby Roland service center.
—
Message list
Indication Meaning
Lock
The Panel Lock function is on (p. 11).
Amazing
M:PU
When playing back a song, this is shown if the song starts on an upbeat.
Auto Off
30
When the Auto O function is activated, and there is between 30 minutes and 1 minute remaining before the power will be turned o, the remaining time (in
minutes) will blink in the display.
USB MIDI
ON
This message appears when you connect the F-120R’s USB port to your computer (“ON”) or when you disconnect it (“OFF”).
Error: 1 You can only read the music le. It can not be saved.
Error: 2
An error occurred during writing. The external media may be corrupted.
Insert other external media and try again. Alternatively, you can initialize the external media.
The external media’s protect tab may be in the “Protect” (writing prohibited) position may not yet be initialized.
Error: 10 No external media is inserted. Insert the external media and try again.
Error: 11
There is not sucient free memory in the save destination.
Either insert other external media or delete unneeded les and try again.
Error: 14
An error occurred during reading. The external media may be corrupted.
Insert other external media and try again. Alternatively, you can initialize the external media.
Error: 15 The le is unreadable. The data format is not compatible with the unit.
Error: 16
Data was not called up in time for playback of the song. After waiting several seconds, you may be able to play back the song by pressing the [
] button
again.
Error: 18
This audio format is not supported.
Please use 44.1 kHz 16-bit linear WAV format audio les.
Error: 30 The memory capacity of the F-120R’s internal memory or the connected USB memory is exhausted.
Error: 40
The unit cannot deal with the excessive MIDI data sent from the external MIDI device.
Reduce the amount of MIDI data sent to the unit.
Error: 41 A MIDI cable has been disconnected. Connect it properly and securely.
Error: 43 A MIDI transmission error has occurred. Check the MIDI cable and connected MIDI device.
Error: 51
There may be a problem with the system. Repeat the procedure from the beginning. If it is not solved after you have tried several times, contact the Roland
service center.
Error: 65
The USB ash drive connector was subjected to excessive current. Make sure that there is no problem with the external media, then turn the power o, then on
again.
To Next Page
Loading...
Need help?
General
