Roland Fantom-S - Getting Ready; Connecting an Amp and Speaker System

3
Getting Ready
Connecting an Amp and Speaker System
Since the Fantom-S contains no amplifier or speakers, you’ll need to connect it to audio
equipment such as a keyboard amplifier, monitor speaker system or home stereo, or use
headphones to hear its sound.
1.
Before hooking anything up, make sure that the power on all of your gear is
turned OFF.
2.
Connect one end of the supplied power cable to the Fantom-S, and the other
end to a power outlet.
3.
Connect the Fantom-S to your amp/speaker system as shown in the diagram.
fig.Q-01.e_80
Use audio cables to connect audio equipment such as an amp or speakers. If you’re using
headphones, plug them into the PHONES jack.
Monitor speakers
(powered)
Power amp
Mixer etc.
Stereo headphones
to Power outlet
To prevent malfunction and/
or damage to speakers or other
devices, always turn down the
volume, and turn off the
power on all devices before
making any connections.
In order to fully experience the
Fantom-S’s sound, we
recommend using a stereo
amp/speaker system. If you’re
using a mono system,
however, make your
connections to the Fantom-S’s
OUTPUT A (MIX) jack L
(MONO).
Audio cables are not included
with the Fantom-S. You’ll need
to provide them.
For details on how to install a
Wave Expansion Board (sold
separately), refer to “Installing
the Wave Expansion Board”
(Owner’s Manual; p. 203).
Fantom-s_e.book 3 ページ ２００３年５月１５日 木曜日 午後１時２５分