5
Getting Ready
3.
Turn on the power for any connected amplifiers or speakers.
4.
Play the Fantom-S’s keyboard, gradually increasing the setting of its volume
control, and then carefully raise the volume of your connected amplifiers or
speakers to the desired listening level.
fig.Q-03
Adjusting the Display Contrast (LCD Contrast)
The characters in the display may be difficult to view immediately after turning on the Fantom-
S’s power or after extended use. Your viewing angle or the current lighting conditions can also
affect the appearance of the display. In such situations, you can turn the CONTRAST knob
(located on the rear panel) to adjust the contrast of the display.
fig.Q-04
Turning Off the Power
1.
Before you turn off the power, consider these two questions:
• Have the volume controls for the Fantom-S and all connected audio devices been turned to
their lowest settings?
• Have you saved your Fantom-S sounds or other data you’ve created?
2.
Turn off the power for all connected audio devices.
3.
Turn off the POWER ON switch of the Fantom-S.
Be careful not to set your
listening volume too high to
avoid damage to your amp/
speaker system or your
hearing.
Fantom-s_e.book 5 ページ ２００３年５月１５日 木曜日 午後１時２５分
To Next Page
Loading...
Need help?
General
