38
Using the Sequencer to Create a Song
2
Set the parameters of the Recording Standby window as shown
below. Press [CURSOR] to move the cursor to each parameter, and
turn the VALUE dial or press [INC] or [DEC] to select the desired
value.
Track: AUTO
Specify the phrase track on which you want to record. If you select “AUTO,” the part
(current part) selected in the MULTITIMBRE PLAY screen will automatically be
specified as the recording-destination phrase track.
Mode (Recording Mode): MIX
Select how recording is to take place. If you select “MIX,” if a performance has
already been recorded on the recording-destination track, your newly recorded
performance will be added to the existing performance without erasing it.
Count In: 1 MEAS
Select how recording is to begin. If you select “1 MEAS,” when you press [STOP/
PLAY], a count (playback) will begin one measure before the recording-start
location, and recording will begin when you reach the recording-start location.
* Parameters other than those listed above will not be used in this example, and need not be set.
Playing and Recording Rhythm Patterns
1
Make sure that the parameters of the Recording Standby window are
set correctly.
2
Press [RHYTHM] so its indicator blinks.
3
Press [STOP/PLAY].
The Recording Standby window closes, and the [REC] indicator changes from
blinking to lit. After a one-measure count, recording begins.
4
Press a key (C4–B4) to which a rhythm pattern has been assigned.
The rhythm pattern assigned to the key plays, and the performance is recorded on
Track 10.
5
When you finish recording, press [STOP/PLAY].
The [REC] indicator goes dark.
6
Press [RHYTHM] to make its indicator light turn off.
7
Press [RESET] to return to the first measure, and then press [STOP/
PLAY] to play back your recording and verify that the rhythm pattern
was recorded correctly.
If you are not satisfied with the
realtime recording you just
made, you can press [MENU],
and from the Menu window
that appears, select “Undo
Realtime Recording” to return
to the state prior to recording
(Undo).
To Next Page
Loading...
Need help?
General
