Roland S-1

Using the menus
69
Item
Value
Explanation
vELo
(Key Velocity)
1–127
Sets the keyboard velocity.
tUnE
(Tune)
433.0–448.0
Sets the master tuning.
Default value: 440.0 Hz
USb.d
(USB Direct Out)
OFF, 1–127
Configures the volume of the signal output to USB.
OFF: Uses the VOLUME knob’s setting.
1–127: Sets the volume apart from the VOLUME knob’s setting.
A.LnK
(AIRA Link) (*2)
OFF, On
Set this to “On” when connecting a device via USB that is compatible with AIRA LINK,
such as the MX-1.
Otherwise, leave this at the “OFF” setting. The setting takes effect after the unit is
powered off and on again.
Cnt.I
(Count In)
OFF, 2–4
Sets the length (the number of beats) of the count-in for recording.
Ntro
(Metronome)
OFF, rEC (Rec),
rC.PL (Rec&Play)
Sets whether and when the metronome plays.
OFF: Always off
rEC (Rec): Turns on only when recording
rC.PL (Rec&Play): Turns on during recording and playback
Ntr.L
(Metronome
Level)
0–100
Sets the metronome level.
d.Lat
(D-Motion Latch)
OFF, On
Sets whether to use latch operations for the [D-MOTION] button or not.
Default value: OFF
OFF: D-MOTION turns “ON” while you press the button (momentary operation).
On: D-MOTION toggles between ON/OFF each time you press the button (latch
operation).
COPy
(Pattern Copy)
Copies the current pattern to a specified pattern. The copy destination number is shown in the display.
Use the [TEMPO/VALUE] knob to select the copy destination number.
● Press pad [2] (ENTER) to copy.
● If you want to cancel, press pad [1] (EXIT).
init
(Pattern Initialize)
Initializes the currently selected pattern (performance data and tones).
rLod
(Reload All)
rL.Sd
(Reload Sound)
rL.Sq
(Reload
Sequence)
Reloads the pattern.
rLod (Reload All): The selected pattern is restored to its last saved state.
rL.Sd (Reload Sound): The tone of the selected pattern is restored to its last saved state.
* You can also hold down the [SHIFT] button and press the [1] + [POLY] pads to do this.
rL.Sq (Reload Sequence): The performance data of the selected pattern is restored to its last saved state.
*1: The settings are made for the currently selected pattern (and can be saved for each pattern).
*2: When using with another port besides the USB HOST 3 port on the MX-1, the unit starts up in battery-only mode. To use
battery-only mode, turn on the power while holding down pad [1] (EXIT).